The solution of swinging screen blocking caused by wet material
1.Use tools to adjust the Angle of vibration motor exciter to increase the excitation force, increase the material jumping force to reduce the adhesion, the smaller the Angle of the exciter, the greater the excitation force.
2. Thickened vibration motor exciter, some of the original vibration motor exciter is relatively light, it is difficult to make the screen has a larger jumping force.
3. Some materials can be washed with clean water, which can dilute materials to reduce the bonding force of materials.Misericordia senhor
4. Wet material relatively dry material screen life is short, serious blocking at the same time more trouble to clean, so more screen should be prepared to replace in time to avoid affecting production.
5. Increase manual cleaning, every three times after the end of the vibrating screen work speed through manual cleaning in a timely manner, usually more than two hours without cleaning the screen is easy to dry bonding more difficult to clean, the second cleaning of materials is more difficult, it is suggested that the production site equipped with a high-pressure water gun better effect.
6. The screen surface of the three-dimensional vibrating screen is equipped with a net cleaning device, and the brush is more common.
